11.5 Actions
Figure 263: Actions Page
Tasks
Use the Actions page to perform the following tasks:
l Pause or resume the replication service (see "Replication Service" on page 378).
l Enable or disable the replication state (see "Replication State" on page 379).
l Clear cumulative replication statistics (see "Replication Performance" on page 379).
Replication Service
The replication service controls replication and failback traffic on the ETERNUS CS800. You
can pause each replication target independently.
l Click Pause next to a target to pause all replication and failback traffic to that target.
If a replication job is currently in progress, the system continues to replicate the
current block of data. The process of replicating the current block can take up to 15
minutes to complete. After the block has completed replication, the system pauses
replication.
ETERNUS CS800 378
To Next Page
Loading...
