12.5 VTL Status
l If a cartridge is mounted in the tape drive, the barcode of the cartridge displays
beneath the drive.
l Click a tape drive to view detailed information about the drive.
Storage and I/E Slots
The Storage Slots and I/E Slots sections displays information about the virtual cartridges
located in the storage and I/E slots:
The following information is displayed for each cartridge:
Slot The slot where the cartridge is located.
Barcode The barcode of the cartridge.
WP The write protect status of the cartridge.
Capacity The capacity of the cartridge.
Used The amount of space on the cartridge currently used to
store data. The value for Used might be less than the
original, native (raw) data size because the data is
compressed before it is written to the media.
Used Percent The amount of currently used space on the cartridge
expressed as a percentage of the total capacity
( [ Used / Capacity ] x 100 ).
l Click a cartridge to view detailed information about the cartridge.
l When the storage system is degraded, all tape cartridges are shown in a degraded
state.
l When the storage system has failed or is inaccessible due to failure, all tape cartridges
are shown as unavailable.
Logical View
Use the Logical View page to view information about the virtual (logical) components in
a VTL partition. You can also view information about used space in the partition.
To access the Logical View page, on the VTL Status page, click the Logical View tab (see
"Logical View Page" on page 399).
ETERNUS CS800 398
To Next Page
Loading...
