14.6 Software Upgrades
Before you begin, download the software image on a computer connected to the Internet,
and then copy the software image (.fw) file to the computer you will use to access the
ETERNUS CS800 remote management console.
To access the Software Upgrade page, click the Utilities menu, and then click the Software
Upgrade tab (see figure below).
Figure 301: Software Upgrade Page
To upload a new ETERNUS CS800 software image:
1. Click the Browse button to browse the system and locate the new software image.
2. Click Upload.
3. Click Start to begin the upload process.
Do not close the window until the uploading and unpacking process is complete. An
Information message displays stating the software image was uploaded successfully.
4. Click OK.
5. Click Install.
If necessary, click the link to delete any outstanding administration alerts before
proceeding.
The Software Upgrade Utility displays (see "Software Upgrade Utility - Software Image
Uploaded" on page 429).
ETERNUS CS800 428
To Next Page
Loading...
