Chapter 4 Connectivity Management
4.2 Host Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
370
(6) After adding the FC host is complete, click the [Add] button.
A confirmation screen appears.
4 Click the [OK] button.
Registration of the FC host group starts.
5 Click the [Done] button to return to the [Host Group] screen.
■ Example of changing the host response when adding a host group
When a host "Host_G3" (host response: HR_1) is created with "Host-3" and "Host-4" and added to the host
groups listed in the table above, the host response is changed as follows:
Click the [Continue] button to continue registering FC host groups.
Host group (Host response) Member host Host response that is allocated to the host
Host_G1 (Default)
Host-1 Default
Host-2 Default
Host_G2 (Default)
Host-2 Default
Host-3 Default
1. The host response for Host-3 is changed from "Default" to "HR_1" (the host response for Host_G3).
2. Since the host response for Host-3 is changed, the host response for Host_G2 to which Host-3 belongs is also
changed from "Default" to "HR_1".
(The host response for Host_2, which is the member host of Host_G2, is changed from "Default" to "HR_1".)
3. Since the host response for Host-2 is changed, the host response for Host_G1 to which Host-2 belongs is also
changed from "Default" to "HR_1".
(The host response for Host_1, which is the member host of Host_G1, is changed from "Default" to "HR_1".)
To Next Page
Loading...
