Chapter 4 Connectivity Management
4.2 Host Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
369
(3) Manually specify the WWN of the host that is to be registered.
The main setting item is as follows.
● Host Setting
• WWN
(4) Click the [OK] button
Returns to the [Manual Input] screen.
(5) Repeat Step (2) through Step (4) to set more WWNs.
If an error screen appears under the following conditions, check the parameter settings.
• The "WWN" is not entered
• The "WWN" does not satisfy the input conditions
If an error screen appears under the following conditions, check the parameter settings.
• The "Host Group Name" is not entered
• The "Host Group Name" does not satisfy the input conditions
• The "Host Group Name" overlaps with an existing host group name
(Host group names cannot overlap with any other host group names, irrespective of the interface
types.)
• When the several FC hosts with the same WWNs have been registered
• No hosts are registered in the host group, or more than eight hosts (or more than 64 for the
ETERNUS DX8700 S3/DX8900 S3) are registered
• The total number of host groups has exceeded the maximum number for the ETERNUS DX
• The total number of hosts has exceeded the maximum number for the ETERNUS DX
• A host with an unrecognizable LUN is added
To Next Page
Loading...
