Chapter 4 Connectivity Management
4.2 Host Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
384
(4) Click the [OK] button
Returns to the [Manual Input] screen.
(5) Repeat Step (2) through Step (4) to set more SAS addresses.
(6) After adding the SAS host is complete, click the [Add] button.
A confirmation screen appears.
4 Click the [OK] button.
Registration of the SAS host group starts.
5 Click the [Done] button to return to the [Host Group] screen.
If an error screen appears under the following conditions, check the parameter settings.
• The "Host Group Name" is not entered
• The "Host Group Name" does not satisfy the input conditions
• The "Host Group Name" overlaps with an existing host group name
(Host group names cannot overlap with any other host group names, irrespective of the interface
types.)
• The several SAS hosts with the same SAS addresses have been registered
• Nine or more hosts are registered in the host group or no hosts are registered in the host group
• The total number of host groups has exceeded the maximum number for the ETERNUS DX
• The total number of hosts has exceeded the maximum number for the ETERNUS DX
• A host with an unrecognizable LUN is added
Click the [Continue] button to continue registering SAS host groups.
To Next Page
Loading...
