Chapter 4 Connectivity Management
4.2 Host Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
419
(4) Click the [OK] button
Returns to the [Manual Input] screen.
(5) Repeat Step (2) through Step (4) when registering several SAS hosts.
(6) After registering the SAS host is complete, click the [Add] button.
A confirmation screen appears.
3 Click the [OK] button.
Registration of the SAS host starts.
If an error screen appears under the following conditions, check the parameter settings.
• The "Name" is not entered
• The "Name" does not satisfy the input conditions
• The "Name" is already used for the registration target host
• The "SAS Address" is not entered
• The "SAS Address" does not satisfy the input conditions
• The "SAS Address" is already used for the registration target host
If an error screen appears under the following conditions, check the parameter settings.
• The same "Name" is already used in the ETERNUS DX
• The same "SAS Address" is already used in the ETERNUS DX
• The number of hosts that is to be registered is "0"
• The number of registered hosts has exceeded the maximum number for the ETERNUS DX
To Next Page
Loading...
