Fujitsu ETERNUS DX60 S3 - Page 710

Appendix A Parameter List
A.1 System Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
710
A.1.7.3 Setup SNMP Agent Basic Interface
For details about this function, refer to "1.8.3 Setup SNMP Agent Basic Interface" (page 111).
For the factory default settings for this function, refer to "Appendix B Setup SNMP Agent Basic Interface" (page
980).
● Basic Interface
• SNMP Function
• LAN Port used for SNMP
• Authentication Failure
• Engine ID
Description Select whether to "Enable" or "Disable" the SNMP function.
Input condition/
Display contents
• Enable
• Disable
Description When enabling the SNMP function, select the port used for SNMP.
When sending a SNMPv1 trap, the agent-address of the trap sender is the Master CM IP
address of the selected port.
Input condition/
Display contents
• MNT
• RMT
Description When enabling the SNMP function, select "Send SNMP Trap" or "Do not send SNMP Trap"
when authentication fails.
Input condition/
Display contents
• Send SNMP Trap
• Do not send SNMP Trap
Description When enabling the SNMP function, input the engine ID of the SNMP.
The engine ID is a unique identifier used to distinguish the connection target storage
system between the SNMP Agent Manager and the SNMP Agent.
It is not necessary to change the default setting for normal use. The default engine ID of
the ETERNUS DX is as follows:
• Octet 1 - 4
Bitwise OR between the company code (fujitsu=211) and 0x80000000
• Octet 5
0x80 (fixed)
• Octet 6 - 13
WWN of the ETERNUS DX (8 bytes)
Input condition/
Display contents
• Default
• Customize
Input condition when selecting "Customize"
- Alphanumeric characters (0 - 9, A - F, a - f)
- Inputting only "0" or "F" for the "Engine ID" field is not allowed
- 10 - 64 characters (even number)