Appendix A Parameter List
A.1 System Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
727
• All Warning Events
• All Informational Events
• Individual Settings within Severity Level
• Blink Fault LED at warning
Description Select whether to notify when a warning level event occurs. When notifying, select the
notification method.
By selecting or clearing the checkbox, the same setting can be applied for all the events
displayed in the [Warning Level] tab.
Input condition/
Display contents
Checkbox
• Selected
Notify all the events
• Selected (lighter colored checkbox)
Some events are notified and some events are not notified
• Cleared
No events are notified
• -
Not applicable to notification
Description Select whether to notify when an informational level event occurs. When notifying,
select the notification method.
By selecting or clearing the checkbox, the same setting can be applied for all the events
displayed in the [Informational Level] tab.
Input condition/
Display contents
Checkbox
• Selected
Notify all the events
• Selected (lighter colored checkbox)
Some events are notified and some events are not notified
• Cleared
No events are notified
• -
Not applicable to notification
Description "Yes" is displayed when the target notification method ("Host Sense Key Code Qualifier",
"SNMP Trap", "E-Mail", "syslog", "REMCS" or "AIS Connect") is specified for any event in
"Error Severity Level", "Warning Level", or "Informational Level", if not, "No" is displayed.
Input condition/
Display contents
• Yes
• No
Description Select "Enable" when setting the Fault LED in the front panel to blink while a warning
level event occurs, or select "Disable" when setting the Fault LED not to blink.
Input condition/
Display contents
• Enable
• Disable
To Next Page
Loading...
