Appendix A Parameter List
A.1 System Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
728
• Turn on Fault LED when redundant copy is completed
• Display parts (except drive) with error status on LCD
• Display parts (except drive) with warning status on LCD
• Display drives with error status on LCD
Description Select "Enable" when setting the Fault LED of the drive to turn on when a redundant copy
is complete, or select "Disable" when setting the Fault LED not to turn on.
Input condition/
Display contents
• Enable
• Disable
If the Copybackless function is enabled, Fault LED for the failed drive is turned on regardless of this setting after the
redundant copy is complete.
Description Select "Enable" when displaying the part (other than drive) error message on the LCD, or
select "Disable" not to display the message on the LCD.
This is displayed only for the ETERNUS DX8700 S3/DX8900 S3.
Input condition/
Display contents
• Enable
• Disable
Description Select "Enable" when displaying the part (other than drive) warning message on the
LCD, or select "Disable" not to display the message on the LCD.
This is displayed only for the ETERNUS DX8700 S3/DX8900 S3.
Input condition/
Display contents
• Enable
• Disable
Description Select whether to display the drive error message on the LCD. This is displayed only for
the ETERNUS DX8700 S3/DX8900 S3.
• Any Time
Select "Enable" when displaying the drive error message on the LCD at any time
regardless of whether the hot spare disk exists, or select "Disable" if the message
should not be displayed.
• when HS<0
Select "Enable" when displaying the drive error message only if a drive error occurs
when the available hot spare disk is "0", or select "Disable" if the message should not
be displayed. This item can be selected only when the "Display drives with error
status on LCD (Any Time)" checkbox is cleared.
Input condition/
Display contents
• Any Time
- Enable
- Disable
• when HS<0
- Enable
- Disable
To Next Page
Loading...
