EasyManua.ls Logo

Fujitsu ETERNUS DX60 S3 - Page 820

Fujitsu ETERNUS DX60 S3
1082 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Appendix A Parameter List
A.4 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
820
Checkbox to select a host
IP Version
Description Select the iSCSI host checkbox to be registered in a host group.
Input condition/
Display contents
Checkbox
Selected
Cleared
If the iSNS server has not been configured in "4.3.8 Modify iSCSI Port Parameters" (page 446), the iSCSI host
cannot be automatically acquired.
The following restrictions in the environment that is described below apply for the automatic acquirement of
host information (*1) even when the iSNS server is specified.
*1: "iSCSI Name", "IP Version", "IP Address", and "Alias Name"
- When one of the following OSs is used and there are multiple hosts that have the same iSCSI name but
different IP addresses, only the information of one host can be acquired.
Windows Server 2003
Windows Server 2008
Windows Server 2008 R2
Oracle Solaris 10
- When the host OS is Oracle Solaris 11, "IP Version" and "IP Address" cannot be acquired.
The following items can be specified only for the iSCSI hosts that are selected by checkboxes; "IP Version" "IP
Address", "Alias Name", "CHAP User ID", "Change CHAP Password", "CHAP Password", and "Confirm CHAP
Password".
iSCSI hosts that are set for the host affinity of which the Virtual Volume function is enabled are not displayed.
Description Select the IP version of the iSCSI host.
Input condition/
Display contents
IPv4
IPv6
To register an iSCSI host without using an IP address, perform IP version selection as follows:
Select "IPv4" when the IP address format of the iSCSI host is IPv4 (when using an IPv4 host)
Select "IPv6" when the IP address format of the iSCSI host is IPv6 (when using an IPv6 host)
If the IP address format of the iSCSI host cannot be checked (when either an IPv4 host or an IPv6 host is used),
register two hosts. Select "IPv4" for one host, and select "IPv6" for the other host. Specify the same iSCSI name,
Challenge Handshake Authentication Protocol (CHAP) user ID, and CHAP password for each host.

Table of Contents

Other manuals for Fujitsu ETERNUS DX60 S3

Related product manuals