Appendix A Parameter List
A.4 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
821
• IP Address
• Alias Name
• CHAP User ID
• Change CHAP Password
Description Specify the IP address of the iSCSI host.
There are two methods to specify an IP address; "IPv4" and "IPv6". The IP address must be
specified with the selected IP version (IPv4 or IPv6). The following IPv6 addresses can be
used; "link local address", "global address", "unique local address", or "6to4 address".
Refer to "Available IPv6 Address" (page 107)
for details. When the current setting is
displayed, the IPv6 address is displayed as an abbreviation.
It is not necessary to specify this item if IP address is not used.
Input condition/
Display contents
• For IPv4 address
xxx.xxx.xxx.xxx
xxx: 1 - 255 for the top field (decimal)
xxx: 0 - 255 for other fields (decimal)
• For IPv6 address
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx
xxxx: 0 - ffff (FFFF) (hexadecimal, alphanumeric characters)
Refer to "IPv6 Address Notation" (page 378)
for details.
Description Specify the Alias name of the iSCSI host.
If the iSCSI host has already been registered in the ETERNUS DX, the Alias name is
displayed.
It is not necessary to specify this item if Alias name is not used.
An existing Alias name cannot be specified.
Input condition/
Display contents
• Up to 31 alphanumeric characters and symbols (except "," (comma) and "?")
• Spaces
Description Specify the user ID for the CHAP Authentication.
If the iSCSI host has already been registered in the ETERNUS DX, the user ID is displayed.
It is not necessary to specify this item if the CHAP Authentication is not used.
Make sure to set the user name and password together.
Input condition/
Display contents
• Up to 255 alphanumeric characters and symbols (except "," (comma) and "?")
• Spaces
Description To register the CHAP Authentication password, select the checkbox.
Input condition/
Display contents
Checkbox
• Selected
• Cleared
To Next Page
Loading...
