Appendix A Parameter List
A.4 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
858
• Basic Interface
- Reset Scope
- Release Reservation if Chip is Reset
- CmdSN Count
Description Specify the reset scope of the target port.
Reset scope is the range where the command reset request from the server is
performed, when the target port is connected to multiple servers.
Input condition/
Display contents
• I_T_L (I: Initiator, T: Target, L: LUN)
Reset (cancel) the command request from the server that sent the command
reset request.
• T_L (T: Target, L: LUN)
Reset (cancel) the command request from all of the servers that are connected to
the port.
This item is displayed when the port mode is "CA" or "CA/RA".
Description Select whether to "Enable" or "Disable" the function to release the reserved status of
the volume when the target port (chip) is reset.
Input condition/
Display contents
• Enable
• Disable
This item is displayed when the port mode is "CA" or "CA/RA".
Description Change the number of commands that can be accepted from the host to the target
port at the same time.
It is not necessary to change the setting from "Unlimited" for normal use.
Input condition/
Display contents
• Unlimited
• 180
• 100
• 80
• 40
• 20
This item is displayed when the port mode is "CA" or "CA/RA".
To Next Page
Loading...
