● Auto mode 1 (Bypass by combination of length and position)
The scanner memorizes the length and location of the paper (overlap pattern) that caused a multifeed
error and continues scanning. When a paper attachment of a similar pattern is detected, the scanner
ignores it to suppress multifeed detection. (*1)(*2)
● Auto mode 2 (Bypass by length)
The scanner remembers the length of the paper (overlap pattern) that caused a multifeed error and
continues scanning. When a paper attachment of the same length or shorter is detected, the scanner
ignores it to suppress multifeed detection. (*2)
*1:Up to eight overlap patterns can be memorized in this mode. When the 9th overlap pattern is detected,
the first pattern that was memorized is erased from the memory.
*2:To erase the memorized overlap patterns and the longest overlap length, press the [iMFF] and [Counter
Reset] buttons at the same time for more than two seconds while [Ready] is displayed on the LCD. The
LCD will display or when the memory is erased. This allows you to erase multifeed patterns
and the longest overlap length that were not supposed to be memorized. Be careful with this operation
because all memorized patterns will be erased.
Multifeed patterns can also be erased from the Software Operation Panel or [1: iMFF Setting] in the [Main
Menu] of the operator panel.
Various Ways to Scan
114
To Next Page
Loading...
