Fujitsu fi-7900 - Page 210

Item Description Setting/Value Factory Default
It can also be configured from
the scanner driver's setup
dialog box. Note that priority is
given to the setting with a
larger value.
(A: Image, B: Filled area, A+B:
Output)
Document check
area specification
for Multifeed
Detection
Selected range: Select this item
to restrict the area to run
multifeed detection on.
[Selected range] check box Not selected
Enable/Disable (Left/Middle/
Right): Specify whether to
enable or disable multifeed
detection for the specified
area.
Enable / Disable
(when [Selected range] is
selected)
Disable
Start: Specify the start point of
the check area in length (mm)
from the top edge of the
document.
0 to 510 mm (in increments of
2 mm)
0 mm
End: Specify the end point of
the check area in length (mm)
from the top edge of the
document.
0 to 510 mm (in increments of
2 mm)
0 mm
Intelligent
Multifeed Function
When there is paper of the
same size attached to a
designated location on the
page, configure the scanner to
memorize the location of the
attachment and not detect
multifeeds for that location.
Note that you first need to
select [Check Overlapping
(Ultrasonic)] for the multifeed
detection setting in Specifying
a Multifeed Detection Method
[Multifeed] (page 252) or the
scanner driver's setup dialog
box.
It can also be configured from
the operator panel.
Manual mode / Auto mode 1 /
Auto mode 2
Manual mode
Select to clear the overlap
pattern (length, location)
memorized in Auto mode.
[Clear overlap pattern] check
box
Not selected
Operational Settings
210