Fujitsu fi-7900 - Page 211

Item Description Setting/Value Factory Default
Specify whether or not to
memorize the multifeed
pattern in the window that
shows the multifeed image.
[Auto-Memorize MF Pattern
(only when MF images are
displayed)] check box
Not selected
Specify whether or not to
memorize the multifeed
pattern at power-off.
Remember / Do not remember Do not remember
Number of paper
feeding retries
Configure this setting to
change the number of feeding
retries upon pick errors.
It can also be configured from
the operator panel.
1 to 12 times 3 times
Retain current
paper thickness
Specify whether or not to
memorize the paper
separation force setting of the
operator panel upon turning
the power off.
Remember / Do not remember Do not remember
Cleaning Cycle Specify the cycle for cleaning
the scanner.
Also specify whether or not to
show a message for cleaning
from the scanner driver.
1,000 to 255,000 sheets
(in increments of 1,000)
[Show cleaning instructions.]
check box
10,000 sheets
Not selected
Life Counter Alarm
Setting
Specify the replacement cycles
for the consumables.
Each consumable
10,000 to 2,550,000 sheets
(in increments of 10,000)
600,000 sheets
Set the interval for
feeding sheets
If the bottom of the scanned
image is partially missing due
to a large skew when scanning
in Automatic Page Size
Detection, specify a longer
interval to feed the
documents.
Specifying a longer interval
leaves more time between
each document to be scanned.
Short (default) - Long
(1 to 4 levels)
Short (default)
Pick Speed When multifeeds or paper jams
occur frequently, the symptom
may be improved by slowing
down the speed (pick speed) in
which the documents are fed.
Normal / Slower Normal
Operational Settings
211