Item Description Setting/Value Factory Default
It can also be configured from
the operator panel.
Soft Pick Setting When you experience pick
errors from the separator roller
slipping on the paper, or paper
jams from scanning thin
papers of small widths, the
symptom may be improved by
bringing down the pick roller
unit and keeping the unit at
the lower position (disabling
the Soft Pick Setting).
It can also be configured from
the operator panel.
Enable / Disable Enable
AutoCrop Boundary Specify whether or not to
optimize (round up/down) the
fractional part of the scanned
image data.
Normal / Optimize Normal
Auto color Detection Specify the slice level for Auto
Color Detection.
1 to 255 levels 5
Alarm setting Specify whether or not to
sound an alarm when an error
such as multifeed or paper jam
occurs.
It can also be configured from
the operator panel.
Disable alarm / Low volume
alarm / High volume alarm
Disable alarm
Jam Detection
outside of
scannable area
when transporting
paper
Specify whether or not to judge
the symptom as paper jam
when a document is skewed
and passes outside the
supported scanning area.
Enable / Disable Enable
Imprinter selection Specify which imprinter to use
when both the Front-Side
Imprinter and Back-Side
Imprinter are installed.
It can also be configured from
the scanner driver's setup
dialog box. When [Normal
(obey Host specification)] is
selected, priority is given to
the scanner driver settings.
Normal (obey Host
specification) /Forcibly select
Front-Side Imprinter /Forcibly
select Back-Side Imprinter
(when the imprinter option is
installed)
Normal (obey Host
specification)
Operational Settings
212
To Next Page
Loading...
