Fujitsu fi-7900 - Page 214

Item Description Setting/Value Factory Default
documents when Paper
Protection is enabled.
Scan Setting for
Document with Tab
(Automatic Page
Size Detection)
For documents with index tabs
or index stickers attached on
the bottom of the page, you
can keep the tab (index or
index stickers) on the scanned
image when scanning in
Automatic Page Size Detection.
Specifying [Document with
tab] shows the image of the
tab, but slows down the
scanning speed.
Document with tab / Document
without tab / Non-rectangular
document
Document without
tab
Maintenance and
Inspection Cycle
Specify the cycle for scanner
maintenance and inspection to
be performed by a service
engineer.
When the specified time period
elapses since the last
periodical maintenance and
inspection, a message for
periodical maintenance
appears.
Disable / Enable
Maintenance/Inspection cycle:
1 to 12 months
Disable
Overscan Control Outputs the image in the
optimum position when the
image is partially missing due
to a large skew.
Normal / Optimize
Black frame thickness:
Thin (Default) to Thick (level 1
to 3)
Normal
Low-speed Feed
Mode
Select whether to perform a
slow scanning speed, in order
to protect the documents.
It can also be configured from
the operator panel.
Disable / Enable Disable
Automatic
Separation Control
Select whether to control the
paper separation force
automatically for each
document type.
It can also be configured from
the operator panel.
Disable / Enable Enable
Stacking Control Set the control for ejecting
documents when scanning
Stackability Emphasis /
Normal / Speed Emphasis
Normal
Operational Settings
214