CHAPTER 3
Small Configuration
Installing the LAS2 Shelf
3-67
FLASHWAVE 7500 Release 6.1
Equipment Installation
Fujitsu and Fujitsu Customer Use Only
FNC-7500-0061-200
Issue 1, May 2009
6 Using four pan-head Phillips M4 screws (8 mm long) on each side, secure the left and right
shelf flanges to the FC9503LAS2 shelf as shown in Figure 3-50 [p. 3-64].
Figure 3-54 [p. 3-67] shows a right-side view of the FC9503LAS2 shelf after the flange is
mounted.
7 Proceed to Step 12 [p. 3-68].
8 Get the flange kit for 23-inch rack mounting. Table 3-6 [p. 3-65] lists the flange kit part
numbers.
9 Identify the left and right shelf flanges. See Figure 3-51 [p. 3-64].
10 Identify the flange mounting holes for 23-inch rack installation on the side of the
FC9503LAS2 shelf. See Figure 3-55 [p. 3-67].
Figure 3-54: Flange Mounted on Right Side of FC9503LAS2 Shelf (19-Inch Rack Installation)
Figure 3-55: Flange Mounting Holes on Right Side of FC9503LAS2 Shelf (23-Inch Rack Installation)
To Next Page
Loading...