Fujitsu FLASHWAVE 7500 - Page 369

CHAPTER 6
Installing/Removing Modules, Filler Panels and Plug-In Units
Installing/Removing Filler Panels
6-7
FLASHWAVE 7500 Release 6.1
Equipment Installation
Fujitsu and Fujitsu Customer Use Only
FNC-7500-0061-200
Issue 1, May 2009
6.4 Installing/Removing Filler Panels
This procedure provides instructions for removing and installing filler panels. It includes the
NO.SUBPROCEDURE PAGE
following subprocedures: Procedure
6.4.1 Removing Filler Panels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-7
6.4.2 Installing Filler Panels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-9
6.4.1 Removing Filler Panels
Remove a filler panel as follows:
Step Task
1 Locate the filler panel that is to be removed. See Figures 6-4 [p. 6-9] and 6-5 [p. 6-10].
2 Press the top and bottom release tabs and gently pull the filler panel unit out of the shelf, as
shown in Figure 6-3 [p. 6-8].
This procedure is complete.
Revision 1, June 2009