Fujitsu SPARC EnterpriseM3000

Chapter 2 Setting Up XSCF 2-167
Assigning or Configuring a System Board to a Domain
■ Command operation
1. After the DCL information, use the showfru(8), showdcl(8) commands to
display XSB status information.
2. Use the showboards(8) command to display XSB status information.
XSCF> showfru –a sb
Device Location XSB Mode Memory Mirror Mode
sb 00 Uni no
sb 01 Quad no
XSCF>
XSCF> showdcl -va
DID LSB XSB System No-Mem No-IO Float Cfg-policy
02 Powered Off System
00 00-0 False False False
01 -
02 -
03 -
04 -
05 -
06 -
07 01-0 False False False
08 01-1 False False False
09 01-2 False False False
10 01-3 False False False
11 -
12 -
13 -
14 -
15 -
<Example> Display detailed information about XSBs.
XSCF> showboards –va
XSB R DID(LSB) Assignment Pwr Conn Conf Test Fault COD
---- - -------- ----------- ---- ---- ---- ------- -------- ----
00-0 SP Available n n n Passed Normal n
01-0 SP Available n n n Passed Normal n
01-1 SP Available n n n Passed Normal n
01-2 SP Available n n n Passed Normal n
01-3 SP Available n n n Passed Normal n