Chapter 2 Setting Up XSCF 2-137
Setting SNMPv3 Trap
■ Command operation
1. Use the showsnmp(8) command to display SNMP settings.
2. Use the setsnmp(8) command to make SNMPv3 trap settings.
<Example> Display of the status when settings have been made for
SNMPv1 and SNMPv2c
XSCF> showsnmp
Agent Status: Enabled
Agent Port: 161
System Location: MainTower21F
System Contact: foo@example.com
System Description: DataBaseServer
Trap Hosts:
Hostname Port Type Community String Username Auth Protocol
-------- ---- ---- ---------------- -------- --------------
host1 162 v1 public n/a n/a
host2 1162 v2 public n/a n/a
SNMP V1/V2c:
Status: Enabled
Community String: public
<Example> Specify a user name, an engine ID, an authentication
algorithm, authentication and encryption passwords, and the host
name or IP address of the trap destination
XSCF> setsnmp addv3traphost -u yyyyy -n 0x### -r SHA host3
Authentication Password: *****
Encryption Password: xxxxxxxx
To Next Page
Loading...
