Appendix B XSCF Log Information B-13
B.6 Active Directory Log
This section explains how to reference the Active Directory logs by using the
showad(8) command. For details of each log option of showad(8), see the XSCF
Reference Manual or the main page. See
TABLE 8-3 for the size and generation number
of each log.
Using the showad(8) Command to Confirm the Active Directory Log
● Perform the showad(8) command on the XSCF Shell.
When the Active Directory authentication and authorization for users, the
diagnostic messages are logged. This log is for use in troubleshooting and is
cleared on XSCF reset. Specify the log option on the XSCF Shell and perform the
showad(8) command to reference Active Directory logs. The following items are
displayed:
■ Time at which each Active Directory log was collected.
■ Console message
B.7 LDAP/SSL Log
This section explains how to reference the LDAP/SSL logs by using the
showldapssl(8) command. For details of each log option of showldapssl(8), see
the XSCF Reference Manual or the main page. See
TABLE 8-3 for the size and
generation number of each log.
Using the showldapssl(8) Command to Confirm the LDAP/SSL Log
● Perform the showldapssl(8) command on the XSCF Shell.
When the LDAP/SSL authentication and authorization for users, the diagnostic
messages are logged. This log is for use in troubleshooting and is cleared on XSCF
reset. Specify the log option on the XSCF Shell and perform the showldapssl(8)
command to reference LDAP/SSL logs. The following items are displayed:
■ Time at which each LDAP/SSL log was collected.
To Next Page
Loading...
Need help?
General