5-14 SPARC Enterprise Mx000 Servers XSCF User’s Guide • January 2012
showntp / showdate
The showntp(8) command displays the NTP server configured with the server and
the XSCF's own local clock informations. The showdate(8) command displays the
system standard time (XSCF time). The system administrator can use the
showdate(8) command to determine the reference time used in the server.
showstatus
The system administrator can use the showstatus(8) command to list degraded
components.
5.5 Domain Control and Maintenance
Commands
This section describes the typical XSCF Shell commands that manage resource
assignment to domains and resource removal from domains, install devices, remove
devices, replace devices, and enable or disable functions.
â– showdevices / cfgdevice
â– console
â– showdcl / setdcl
â– showfru / setupfru
â– addfru / deletefru / replacefru
â– showboards / addboard / deleteboard / moveboard
â– showdomainmode / setdomainmode
showdevices / cfgdevice
The cfgdevice(8) command displays the domain to which a DVD drive unit or
tape drive unit is assigned. Also, the cfgdevice(8) command can be used only on
M8000/M9000 servers. The showdevices(8) command displays the operating status
of resources installed on a system board (XSB). The system administrator can use
this command to determine the devices to be assigned to a domain and check
whether the DR function can be used to connect or disconnect an XSB.
To Next Page
Loading...
Need help?
General