2-28 SPARC Enterprise Mx000 Servers XSCF User’s Guide • January 2012
This is because the DSCP communication protocol, PPP (Point to Point Protocol),
does not notify the netmask value specified by the -m option to the domain side, and
also because the ifconfig(1M) displays the netmask value corresponding to the
class of IP address in the DSCP interface.
Note – All DSCP addresses must be in the same network subnet.
Specifying a Host Name for XSCF
■ Command operation
1. Use the showhostname(8) command to display host names.
2. Use the sethostname(8) command to specify a host name.
XSCF> showhostname -a
xscf#0: scf-hostname0.company.com
xscf#1: scf-hostname1.company.com
<Example 1> Specify the host name scf0-hostname for XSCFU#0.
XSCF> sethostname xscf#0 scf0-hostname
<Example 2> Specify the domain name com for XSCFU#0.
XSCF> sethostname -d company.com
To Next Page
Loading...
