Fujitsu SPARC EnterpriseM3000 User Manual

4-20 SPARC Enterprise Mx000 Servers XSCF User’s Guide • January 2012
3. Use the showdomainstatus(8) command to check the power status of the
domain specified to be reset.
Note – When the mode switch on the operator panel is set to "Service" or auto boot
is disabled by the setdomainmode(8) command, automatic boot of the Oracle
Solaris OS after the reset instruction is suppressed.
Note – Since the reset(8) command forcibly resets the system, this command may
cause a failure in a hard disk drive or other components. Use this command only for
the purpose of recovery, such as if the Oracle Solaris OS hangs, and for other limited
purposes.
4.4.7 Sending a Break Signal to a Domain
■ Command operation
1. Use the showdomainstatus(8) command to confirm the domain status.
2. Use the sendbreak(8) command to send a Break signal to the specified
domain.
XSCF> showdomainstatus -a
DID Domain Status
00 Booting/OpenBoot PROM prompt
01 Running
02 Running
03 Running
XSCF> showdomainstatus -a
DID Domain Status
00 Running
01 Running
02 Running
03 Running
XSCF> sendbreak -d 0
Send break signal to DomainID 0?[y|n] :y

Fujitsu SPARC EnterpriseM3000 Specifications

General

Brand	Fujitsu
Model	SPARC EnterpriseM3000
Category	Server
Language	English