B-10 SPARC Enterprise Mx000 Servers XSCF User’s Guide • January 2012
B.4.4 Panic Log
Using the showlogs(8) Command to Reference Panic Logs
In case of panic, a console message is output to the domain console. This console
message is collected by the XSCF firmware in a panic log. In some cases, panic logs
may be called panic message logs. Specify the panic option on the XSCF Shell and
perform the showlogs(8) command to reference panic logs. The following items are
displayed:
â– Domain ID (DomainID)
â– Time at which each panic log was collected (Date). This is indicated in local time.
â– Panic message (Message)
B.4.5 IPL Log
Using the showlogs(8) Command to Reference IPL Logs
After the domain power supply is turned on, console messages are output to the
domain console until the running status is set. These console messages are collected
by the XSCF firmware in an IPL log. In some cases, IPL logs may be called IPL
message logs. Specify the ipl option on the XSCF Shell and perform the showlogs(8)
command to reference IPL logs. The following items are displayed:
â– Domain ID (DomainID)
â– Time at which each IPL log was collected (Date). This is indicated in local time.
â– IPL message (Message)
B.5 Audit Log
This section explains how to reference the audit logs by using the viewaudit(8)
command. For details of each log option, audit class, and audit event of
viewaudit(8), see the XSCF Reference Manual or the main page. See
TABLE 8-3 for the
size and generation number of each log.
To Next Page
Loading...
Need help?
General