Chapter 5 Overview of the XSCF Shell 5-17
5.7 User Management and Security
Commands
This section describes the typical XSCF commands for user management and
security management.
â– showuser / adduser / deleteuser / enableuser / disableuser
â– password / setprivileges / showpasswordpolicy / setpasswordpolicy
â– showlookup / setlookup / showldap / setldap / showad / setad / showldapssl
/ setldapssl
â– showaudit / setaudit / viewaudit
â– showloginlockout / setloginlockout
â– showssh / setssh
showuser / adduser / deleteuser / enableuser / disableuser
The showuser(8) command can be used to list XSCF user accounts or display
information about a particular user account. The adduser(8) and deleteuser(8)
commands add and delete user accounts. The enableuser(8) and disableuser(8)
commands enable and disable, respectively, user accounts.
password / setprivileges / showpasswordpolicy / setpasswordpolicy
The password(8) and setprivileges(8) commands set passwords and user
privileges, respectively, for user accounts. The showpasswordpolicy(8) and
setpasswordpolicy(8) commands display and specify the validity of passwords
and other password policy information.
showlookup / setlookup / showldap / setldap / showad / setad /
showldapssl / setldapssl
The showlookup(8) and setlookup(8) commands display and specify information
on whether an LDAP server should be used for looking up the authentication and
the user privilege. The showldap(8) and setldap(8) commands display and specify
LDAP client settings, which are used when retrieving data from an LDAP server.
The showad(8) and setad(8) commands display and specify Active Directory client
settings, which are used when retrieving user informations from an Active Directory
To Next Page
Loading...
Need help?
General