B-8 SPARC Enterprise Mx000 Servers XSCF User’s Guide • January 2012
(The example is subject to change without previous notice for functional
improvement.)
In the example above, the following items are displayed:
â– Time at which each event log was gathered (Date). This is indicated in local time.
â– Event message (Message).
B.4 Using the showlogs Command to
Display Other Logs
This section explains how to reference the other main logs by using showlogs(8)
command. For details of each log option of showlogs(8), see the XSCF Reference
Manual or the main page. See
TABLE 8-3 for the size and generation number of each
log.
B.4.1 Monitor Message Log
Using the showlogs(8) Command to Reference Monitor Message Logs
An event that occurred in the server is displayed as a monitoring message in real
time for the user who logged in the XSCF. The XSCF firmware collects this message
in a monitor message log. Specify the monitor option on the XSCF Shell and perform
the showlogs(8) command to reference the monitor message log. The following
items are displayed:
â– Time at which the monitoring message was collected (Date). This is indicated in
local time.
â– Monitoring message (Message).
<Example> XSCF event logs are displayed as a list.
XSCF> showlogs event
Date Message
Mar 30 17:45:31 JST 2005 System power on
Mar 30 17:55:31 JST 2005 System power off
To Next Page
Loading...
Need help?
General