Chapter 5 Overview of the XSCF Shell 5-15
console
The console(8) command establishes a connection to the domain console. This
command supports both interactive and read-only connections.
showdcl / setdcl
The showdcl(8) command displays the domain configuration information (DCL)
specified for individual domains or LSBs that compose a domain, and the setdcl(8)
command specifies the configuration. The system administrator refers to and
specifies DCL when adding an XSB to a domain.
showfru / setupfru
The showfru(8) command displays the locations of devices, such as system boards,
mounted in the server and resource partition information, and the setupfru(8)
command specifies these locations and this information. The system administrator
can use the commands for effective use of resources.
addfru / deletefru / replacefru
The addfru(8) command is used to select a device, such as a CPU/Memory Board
unit, I/O unit, fan unit, or PSU, to add it to the server, and the deletefru(8) and
replacefru(8) commands are used to select and remove or replace, respectively,
such a device mounted in the server. Each type of operation can be performed
interactively with menus.
showboards / addboard / deleteboard / moveboard
The showboards(8) command displays status information about a system board
(XSB). The system administrator can use the command to find out whether a system
board has been configured to a domain or unconfigured from it, and to find out
whether this operation was successful. The addboard(8) command adds a system
board to the domain, the deleteboard(8) command removes a system board, and
the moveboard(8) command moves a system board.
Note – In the M3000 server, the domain configuration cannot be changed.
To Next Page
Loading...
Need help?
General