Fujitsu SPARC EnterpriseM3000 - Page 329

Chapter 7 XSCF SNMP Agent Function 7-9
■ Community name
■ Port number of the trap destination
■ Host name of the trap destination
■ Step 3:
Enable the XSCF SNMP agent function. Enable one or both of the following,
according to the user environment:
■ SNMPv1 and SNMPv2c
■ SNMPv3
Note – All MIB information except the setting items in step 2 is initialized when the
XSCF SNMP agent function is enabled.
Caution – IMPORTANT - Since SNMPv1 and SNMPv2c do not provide a capability
to encrypt communication data, neither are secure enough. In SNMPv3, more secure
transmission can be achieved through authentication and encryption settings on
both the agent and manager sides. The server uses SNMPv3 as the default SNMP
agent.
Suspending or Disabling Transmission
[Disabling the XSCF SNMP agent function]
Disable one or both of the following, according to the user environment:
■ SNMPv1 and SNMPv2c
■ SNMPv3
[Disabling sending to the target trap destination host for SNMPv3]
Specify the following to disable sending:
■ User name
■ Trap destination host
[Disabling sending to the target trap destination host for SNMPv1, SNMPv2c]
Specify the following to disable sending:
■ Defined protocol type (v1/v2c)
■ Trap destination host