D-4 SPARC Enterprise Mx000 Servers XSCF User’s Guide • January 2012
A Mail Report Was Not Received From XSCF
■ XSCF does not necessarily report all events. It sends a mail message for each part
fault or authentication failure event. Check for the relevant event in the error log,
or use the reference for event logs in Appendix B to check whether this is an event
in an event log to be reported.
■ Use the showemailreport(8) command to check whether the appropriate setting
is enabled. If no mail message for this event has been received, check whether an
error mail message has been sent to the error mail recipient, or check the log of
recorded errors.
■ If a cellular phone is used for receiving mail messages, check the phone settings
for any set restriction on receiving messages.
Could Not Access the Top Page of the XSCF Web Function
■ Use the showhttps(8) command to check whether the setting for XSCF is
enabled.
■ Check whether the entered URL is correct (e.g., whether the “s” in "https" is
missing).
■ Ask the system administrator to check whether access through the IP address that
is set is permitted.
■ Check whether the SSL/TSL function setting of the web browser is enabled.
Could Not Display XSCF Web Windows
■ If XSCF Web windows are not displayed even after login to the system from the
top page of XSCF Web, JavaScript may be disabled in the web browser settings.
Enable JavaScript in the browser settings, and retry login.
■ If pop-up window display is disabled in the web browser settings, XSCF Web
windows cannot be displayed. Check the browser settings.
Forgot the Login Password for the XSCF Web
■ Since XSCF Web authentication is the same as XSCF Shell authentication, see the
above Forgot the Login Password for XSCF.
Failed in the First Attempt to Access the XSCF Web Function After
Login
■ Check whether Cookies are accepted in the web browser settings.
To Next Page
Loading...
Need help?
General