Fujitsu SPARC EnterpriseM3000 User Manual

2-52 SPARC Enterprise Mx000 Servers XSCF User’s Guide • January 2012
Before Active Directory settings
Note the following before settings:
■ Active Directory is supported in XCP1091 or later.
■ The useradm privilege is required for the Active Directory settings.
■ If the XSCF is configured to use LDAP, Active Directory, or LDAP/SSL for user
account data, the user name and UID (if specified) must not already be in use
locally or in LDAP, Active Directory, or LDAP/SSL.
■ To use host name for Active Directory server, DNS settings need to be configured
properly before setting Active Directory.
■ To support Active Directory, a new system account named proxyuser is added.
Verify that no user account of that name already exists. If one does, use the
deleteuser(8) command to remove it, then reset XSCF before using the Active
Directory feature.
Operator
group
Assigns group name for up to five specified
operator
groups. The operator group has platop and
auditop
privileges and you cannot change that.
setad
Custom group Assigns group name and privileges for up to
five groups.
setad
Timeout Configures transaction timeout, in seconds.
seconds can be 1 to 20.
setad The default is 4. If the
specified timeout is too brief
for the configuration, the
login process or retrieval of
user privilege settings could
fail.
Enable/Disabl
e log
Enables or Disables logging of Active Directory
authentication and authorization diagnostic
messages.
setad This log is cleared on XSCF
reset.
Display log Displays Active Directory authentication and
authorization diagnostic messages
showad
Clear log Clears log file of Active Directory
authentication and authorization diagnostic
messages.
setad
Default Resets Active Directory settings to factory
default.
setad
TABLE 2-8 Active Directory Administration (Continued)
Item Description Shell command Remarks

Fujitsu SPARC EnterpriseM3000 Specifications

General

Brand	Fujitsu
Model	SPARC EnterpriseM3000
Category	Server
Language	English