i
SAFETY INSTRUCTIONS
Leave the equipment powered while
underway. (For antenna maintenance
and the like, turn off the power at the
mains switchboard.)
Distress cannot be communicated unless
the equipment is powered.
Do not disassemble or modify the
equipment.
Fire, electrical shock or serious injury can
result.
Turn off the power immediately at the
ship's mains switchboard if water
leaks into the equipment or the equip-
ment is emitting smoke or fire.
Continued use of the equipment can cause
fire or electrical shock. Contact your
dealer for advice.
Do not locate the terminal unit near
water or places subject to water splash.
Electrical shock, fire or personal injury may
resullt
Any repair work must be done by a
licensed radio technician.
Improper repair work can cause electrical
shock or fire.
Do not open the equipment.
Hazardous voltage which can
cause electrical shock, burn
or serious injury exists inside
the equipment. Only qualified
personnel should work inside
the equipment.
Hazardous microwave.
Do not approach within
60 cm of the antenna radome
when it is transmitting.
Microwave radiation can be
harmful to the human body,
particularly the eyes.
WARNINGWARNING
Radiation Level At
10W/m
0.6 m
2
WARNING LABEL
A warning label is attached to the
terminal unit. Do not remove the label.
If the label is missing or damaged,
contact your dealer about replacement.
Name: Warning Label (2)
Type: 03-129-1001-1
Code No.: 100-236-741
WARNING
To avoid electrical shock, do not
remove cover. No user-serviceable
parts inside.
Use the proper fuse.
Use of a wrong fuse can result in fire or
permanent damage to the equipment.
This equipment is intended for marine
application.
CAUTIONCAUTION
Do not operate the equipment with
wet hands.
Electrical shock may result.
WARNINGWARNING
To Next Page
Loading...
Need help?
General
