Furuno FELCOM 15 Operator's Manual

5. DATA REPORTING AND POLLING
5-4
5.1.2 Setting a message report
1. Press the [F5] key to display the Reports menu.
Reports
1. Data Report
2. Message Report
3. Data Network ID
Reports menu
2. Press the [2] key to display the Message Report menu.
Message Report
1. Message Report 1
2. Message Report 2
3. Message Report 3
4. Message Report 4
Message report menu
3. Press [1], [2], [3] or [4] as appropriate
Message Report
OFF
TELEX
Regular Interval
00:10
1 (- - - : No Limit)
--:--
--:--
--:--
--:--
NAV
PIN Code
Message Report Programming
Status
Station Name
Destination Type
Prefix Code
Country/Ocean Code
Station ID
Modem Type
Address
Subject
LES ID
Activation
Interval Time
Report Times
Start Time1
Start Time2
Start Time3
Start Time4
Report Contents
File
Message report menu
PIN code is unrelated to data reporting, however it is necessary for polling
(see paragraph 5.2). Enter PIN code as shown below.
4. PIN Code is selected; press the [Enter] key to open the PIN code entry
window.
5. Key in PIN code, using up to eight digits. The PIN code is a password used in
message reports. When a ship receives a polling command w/PIN code from
a shore subscriber and the code matches that of the ship, the ship sends a
message report.
6. Press the [Enter] key to close the window.
7. Press the [↓] key to choose Status.
8. Press the [Enter] key to open the status options window.

Furuno FELCOM 15 Specifications

General

Brand	Furuno
Model	FELCOM 15
Category	Marine Radar
Language	English