Gallagher PULSE Series - Adjusting the Volume; Electrical Protection; Wiring Diagram; Cleaning the LCD Screen

SERVICING
113
PULSE Installaon, Commissioning and Servicing Manual - Revision 19
19.5 Wiring Diagram
The figure below shows a basic wiring diagram for the PULSE Media system.
Fuse
HDMI
VGA
Audio (*)
Mains In
12VDC
Power
Supply
Connector
Block
Front
Screen
Rear
Screen
Media Player
Amplifier
Speakers Speakers
Wireless
Antenna
Wireless
Antenna
19.3 Adjusting the Volume
The volume can be adjusted on the amplifier using the volume knob (arrowed).
19.4 Electrical Protection
The media system is protected by a 5A standard small (20x5mm) fuse located in the Mains
Connector Block (arrowed).
Figure 44. Volume Knob
Figure 45. Fuse Location
Figure 46. PULSE Media Basic Wiring Diagram
19.6 Cleaning the LCD Screen
Clean the LCD screen with a soft lint-free cloth and glass cleaner. Do not wash the screen
with a hose as this may cause water to enter the dispenser electronics and adversely
affect the operation of the system.