Gallagher PULSE Series - Service Mode Functions; Summary of New Key Features and Functions

SERVICING
84
PULSE Installaon, Commissioning and Servicing Manual - Revision 19
14 SERVICE MODE FUNCTIONS
This section describes the Service Mode 1.20, including new features and changes to the
existing functions.
14.1 Summary of New Key Features and Functions
The following information summarises the new key features and functions added to the
new service mode. These functions and more are described in detail later in this document.
Stack Menu Has a new stack test function and is able to display the state of
auxiliaries, nozzles, and VR.
Config Allows config to be backed up or restored from the SD card.
Totes Has new save and restore totes function from CC.
StartDel Start delay time can now be set for each hose.
Flow Control Flow control can be turned on and off and target flow rate set per
hose.
Reboot Allows reboot of the Central Controller using the keypad.
POS Can put POS in stand alone mode, toggle between 5 and 6 digit
mode, change POS protocol, turn comms logging off/on.
Mapping Edit/map grade priority.
Timeout Adjustable timeout settings.
VR ATPM (Automatic Tank Pressure Monitoring) and VR2 monitoring
can be turned off/on.
Errors New error displays added and listed in table “Interpreting Errors”
with the “Errors “section.
LPG Menu LPG calibration, addressing and test mode functionality now
available from the UI.
Version 1.20