Gallagher PULSE Series - Installing the Head Lighting; Figure 13� Head Lighting Assembly; Rear Side of the Head

INSTALLATION
35
PULSE Installaon, Commissioning and Servicing Manual - Revision 19
9.6 Installing the Head Lighting
This section describes the process of installing and connecting the Head Lighting Assembly
(Part Number 2A100442) inside a PULSE Head with an Advert User Interface.
The Head Lighting Assembly will be supplied as shown in the following figure.
Lamp holder
Light Mounng Bracket
The assembly also includes:
• 1 x LED bulb (not shown)
• 2 x M4 nuts (not shown)
Ulux Crimp Lugs
Lighng Assembly Cable
Figure 13. Head Lighting Assembly
The installation procedure should be executed through the rear side of the head. The light
mounting bracket should be connected to the 2 studs within the free compartment inside
the head. For the power supply, the Utilux Crimp Lugs should be connected to the Motor
Drive Module.
Studs for light Studs for light
mounng mounng
bracketbracket
Motor Drive Motor Drive
ModuleModule
Figure 14. Rear Side of the Head