Gap Diagnostic IIDTool Pro G3 - Allow Central Configuratin Data Learning (2017-2019); GSM Gear Shift; VIN Learn; Self-Test

134
IIDTool
GAP Diagnostic 2023-09-12 All Rights Reserved
User Manual G3 units: Version 37, Firmware V4.0
Allow Central Conguratin Data Learning (2017-2019)
This routine is used when a CCF change taken into account by this ECU is made. Auto High Beam
Assist and Lane Keep Assist to name a few.
4.7.20 GSM Gear Shift
VIN Learn
This is required when installing a brand new unit. Used one do not require this routine.
Self-Test
This is required when installing a new unit.
4.7.21 ARC Active Roll
Manual Bleed (2017+)
This routine is required when replacing the ARC Active Roll hoses or actuator.
4.7.22 PAM Parking Aid
CCF Relearn (L494-14)
This routine is required when replacing the PAM ECU or changing the CCF.
Reset CCF Learn (2017+)
This routine is required when replacing the PAM ECU or changing the CCF.
4.7.23 IMC Integrated Media Control (2017 to 2019)
CCF Relearn
This routine is required when replacing the ICM ECU or changing the CCF.
4.7.24 Allow Central Conguration Data Learning (2017+)
Usage
This routine is used when a CCF change is made and learning is required for one of the supported
ECU. Auto High Beam Assist and Lane Keep Assist to name a few.
Applies but not limited to the following ECUs;
• IPMA Rear View Mirror (L405 and L494 2017 to 2019, L462 up to 2019)
• IMC Integrated Media Control (2017 to 2019)
• SODL Side Object Detection Left
• SODR Side Object Detection Right
• IDMA Interactive Display Module A (2020+)
• PAM Parking aid, refer to this ECU for more details