184 185
IIDTool
GAP Diagnostic 2023-09-12 All Rights Reserved
User Manual G3 units : Version 37, Firmware V4.0
4.14 IIDTool Cong
4.14.1 Find ECUs
Pre App build 93 iOS, 105 Android
Upon rst use, the IIDTool will scan the communication buses and note which ECUs are responding.
When scanning is complete, the number of ECU found will be displayed. The resulting list is stored in
the IIDTool memory for up to 10 vehicles (except for the IIDTool Pro which has no limit). If a new ECU
is installed or removed from the vehicle, the Find ECU function shall be used to add or remove the
ECU from the list.
From App build 94 iOS, 106 Android
Upon rst use, the IIDTool will scan the communication buses and note which ECUs are responding.
When scanning is complete, the name of ECU found will be displayed in GREEN while those non
preset will be in RED. The resulting list is stored in the IIDTool memory for up to 10 vehicles (except
for the IIDTool Pro which has no limit). If a new ECU is installed or removed from the vehicle, the Find
ECU function shall be used to add or remove the ECU from the list. Click on Validate to refresh the list.
Figure 119. Rechercher Calculateur, Find ECUs
To Next Page
