174 175
IIDTool
GAP Diagnostic 2023-09-12 All Rights Reserved
User Manual G3 units : Version 37, Firmware V4.0
TEL Bluetooth (English UK*, L322-2005, L322-06, L319-04, L320-05)
Updating the Bluetooth ECU on earlier vehicles will improve pairing on more recent mobile devices. It
will also allow phone book access on the radio or navigation screen. It is not necessary to proceed with
this update if these features are already working properly.
Note: This update will only work on units with pairing code 2121. The dealer tted kits (pairing code
0000) cannot be updated.
*Instructions for other voice languages can be found at the end of this section.
Table 37. Risk, updating the Bluetooth ECU
Instructions
Notes on mobile App usage: Once started, the re-ashing process is independent from the App and
is only handled by the IIDTool. The App is only used to display the current status and can be left in the
background, foreground or closed. If the mobile device gets disconnected from the IIDTool, voluntarily
or not, the App will recover automatically once reconnected to the IIDTool.
Steps
L322-2005 and L322-06
• Select the Bluetooth re-ash and follow the instructions on screen.
• The process is done with the key to the Accessory position (I). Make sure that the headlights are
turned o and that any unnecessary lights or accessory are turned o also.
• Upon completion, turn the key to the ON position (II) and follow the instructions on screen.
L319-04 and L320-05
• Select the Bluetooth re-ash and follow the instructions on screen.
• The process is started with the key to Ignition, position II. Once re-ashing has begun (indicated
on the Navigation screen), the key can be removed. It can also be left in position II in which
case the user should keep an eye on the vehicle and wait until completion (the instrument pack
will wake up). Failure to turn the key to the OFF position after the procedure is completed (or if
a failure occurred) will lead to a battery drain if not connected to a power supply.
• Upon completion, turn the key to the ON position (II) and follow the instructions on screen.
Keep an eye on the vehicle and wait until completion (the instrument pack will wake up). Failure to
remove the key from the ignition after the procedure is completed (or if a failure occurred) will lead to
a battery drain if not connected on a power supply.
Risk Level Consequences Recovery Method Precautions
Low
Entertainment system
non functionning
Repeat re-ashing
procedure
The entertainment system, especially
the MOST ring must be in working
order
To Next Page
