Gap Diagnostic IIDTool Pro G3 - Engine (L316-12 with DSC); Steering Angle Sensor Calibration; Active Damping (L322-10); Calibration

94 95
IIDTool
GAP Diagnostic 2023-09-12 All Rights Reserved
User Manual G3 units : Version 37, Firmware V4.0
Preparations
• Turn engine OFF
• Select neutral, depress and hold brake pedal
• Start the routine and follow instructions on screen
Usages
This function is used when:
• The sensor is replaced
• The transfer box ECU is replaced or re-ashed
4.6.6 Engine (L316-12 with DSC)
Steering angle sensor calibration
This routine will calibrate the steering angle sensor center position.
Preparations
• Place the vehicle on a at and level surface.
• Ensure that your front wheels and steering wheel are straight before proceeding.
Usages
This function is used when:
• The steering angle sensor is replaced.
• A wheel alignment is performed on the vehicle.
• It may be required if parts of the steering system have been replaced or removed.
4.6.7 Active Damping (L322-10)
Calibration
Needed when the active damping ECU is replaced or updated.