Gap Diagnostic IIDTool Pro G3 - Synchronizing the Mobile Application

44 45
IIDTool
GAP Diagnostic 2023-09-12 All Rights Reserved
User Manual G3 units : Version 37, Firmware V4.0
2.6 Synchronizing the Mobile Application
Purpose
Refresh les in the Mobile Application IIDControl to achieve consistency with the rmware of the newly
updated tool (section 2.5) or prior to rst usage.
Note: Performing synchronization immediately after updating the tool or before rst usage will prevent
prolong le loading when connected to the vehicle due to a poor Internet connection.
Prerequisites
• Having access to a PC or Mac personal computer. A USB power source is not su󰀩cient, a com-
puter is mandatory.
• Own a compatible mobile device (section 1.7.3) connected on the Internet.
• The IIDControl App is installed and up-to-date (section 2.4)
• The IIDTool rmware was updated (section 2.5) or a new mobile device is used with the tool for
the rst time.
Steps
1- Connect the IIDTool on the USB port of the computer.
2- Launch the mobile Application IIDControl in the mobile device.
3- Click on “ Search for tool ”.
4- Select the tool in “ Bootloader ”. For the rst synchronization, ll the required elds.
5- Wait while all data les are downloaded : the word “ Loaded ” indicates completion.
6- Exit the application by pressing “Disconnect”.
7- Repeat previous steps for each mobile devices that may be used with the tool.
8- Unplug the IIDTool from the computer or USB supply.