34 35
IIDTool
GAP Diagnostic 2023-09-12 All Rights Reserved
User Manual G3 units : Version 37, Firmware V4.0
2 Getting started
2.1 Before rst usage
Here is a compendium of operations to be performed before rst usage. Each of these operations is
described in detail in the referenced section of this manual. This table can serve as a fulllment check
list prior to using the tool.
√ Steps Operations Section
1
st
Determination of the Vehicle’s Model-
Referent code.
section 1.6
2
nd
Create a user account on the website section 2.2
3
rd
Installation of the updater software
on a computer
section 2.3
4
th
Installation of Interfaces :
Mobile App
section 2.4
5
th
Updating the IIDTool’s rmware section 2.5
6
th
Synchronizing the Mobile Application section 2.6
7
th
Consult safety and tips section section 2.7
8
th
Getting to know the tool :
-Connecting to the vehicle’s OBD
connector
-Navigation and Interfaces commands
-Disconnection
section 2.8
9
th
Activating the IIDTool section 2.9
Table 12. Abstract of operations to complete before rst usage
To Next Page
Loading...
