52 53
IIDTool
GAP Diagnostic 2023-09-12 All Rights Reserved
User Manual G3 units : Version 37, Firmware V4.0
Language
The application is available in French and English. It automatically adjusts to the language of the
mobile device. It is recommended that the tool be updated to the same language section 2.5. Thus, the
application and content from the tool will be in the same language.
2.8.4 Disconnecting the IIDTool
The IIDTool was not designed to remain permanently connected to the OBDII port of the vehicle. Dis-
connect the IIDTool after each use.
The IIDTool can be disconnected at any time except:
Warning ! Do not disconnect IIDTool during an ECU ash, or when writing the Car Conguration File
(CCF) as a breakdown or serious consequences could arise (descriptions of these functions and reco-
very methods are found in section 4.10 and section 4.11).
To Next Page
Loading...
