Gap Diagnostic IIDTool Pro G3 - TEL Bluetooth ECU (Other Languages, L322-2005, L322-06, L319-04)

176
IIDTool
GAP Diagnostic 2023-09-12 All Rights Reserved
User Manual G3 units: Version 37, Firmware V4.0
TEL Bluetooth ECU (other languages, L322-2005, L322-06, L319-04)
User can choose between French, Spanish, German, Italian and English US voice languages.
Note: This update will only work on units with pairing code 2121. The dealer tted kits (pairing code
0000) cannot be updated.
Use
IIDTool Pro: all versions are embedded in the IIDTool Pro rmware. Usage of a mobile device is requi-
red.
IIDTool BT: Available upon request only.
Steps:
L322-2005 and L322-06
• Select the Bluetooth re-ash and follow the instructions on screen.
• The process is done with the key to the Accessory position (I). Make sure that the headlights are
turned o󰀨 and that any unnecessary lights or accessory are turned o󰀨 also.
• Upon completion, turn the key to the ON position (II) and follow the instructions on screen.
L319-04
• Select the Bluetooth re-ash and follow the instructions on screen.
• The process is started with the key to Ignition, position II. Once re-ashing has begun (indicated
on the Navigation screen), the key can be removed. It can also be left in position II in which
case the user should keep an eye on the vehicle and wait until completion (the instrument pack
will wake up). Failure to turn the key to the OFF position after the procedure is completed (or if
a failure occurred) will lead to a battery drain if not connected to a power supply.
• Upon completion, turn the key to the ON position (II) and follow the instructions on screen.