GE Security ZP3 - Chapter 4: Software Programming; Introduction

ZP3 Fire Control Panel Installation, Commissioning and Maintenance Manual
REV 11 (ISS 08/03/2010) Page 61
Chapter 4: Software programming
Introduction
The ZP3 fire control panel is a modular system with a powerful software programming capability.
The system requirements are built from standard hardware modules, and the functional
requirements are software programmed into the panel. The software programming system
allows for software programming that meets the needs of virtually any required application.
The configuration can be programmed on a PC-computer using the "Ziton Planner 3" programme,
and loaded into the panel. It can also be programmed directly into the panel via the fascia
keyboard. Programming on a PC is the recommended method because it also allows you to
produce a hardcopy of the system programming for record purposes.
The following main items/features can be programmed into the panel:
 Access control facilities
 Panel identification
 Standalone system or ZP-NET multipanel system
 Fire and non-fire functions
 Sensor allocation to zones
 Individual sensor/device location messages
 Zone identification/location messages
 Input - Output mapping
 Device type and address
 Alarm verification feature
 Sensor Sensitivity
 Sensor with attached sounder
 Loop sounders
 Panel sounders
 Sensor self-test
 Loop Isolators
 Delay on silencing sounders
 Printer and printer options
 Time stamping of event on-screen