[EN] English - K0460 Prepare the instrument 2-1
Chapter 2: Prepare the instrument
2.1 Introduction
This chapter gives a description of these items:
• the initial checks and procedures
• the available power options
• the battery and related procedures (install and charge)
• the start-up procedures
• the menu structure and options
• the Process and Automation options available for the
measure and source ( )functions
2.2 Initial checks
Before using the instrument for the first time:
• Make sure that there is no damage to the instrument, and
that there are no parts missing; see Figure 1-7.
• Remove the plastic film that protects the display. Use the
tag (◗ ) in the top right-hand corner.
2.3 Initial procedures
Before using the instrument for the first time, complete these
procedures:
• Charge the battery (Section 2.5.3).
• Install the fully-charged battery (Section 2.5.2). Then refit
the cover.
• To make sure that the calibration schedule works correctly,
set the date and time; see Section 2.8 (Menu sequence).
2.4 Power supply
This instrument is battery powered:
Ni-MH battery (Section 2.5): All the instrument functions are
available with a fully-charged battery.
To Next Page
Loading...
