GE Druck DPI 620-IS - 2.8.2 Procedure to see the instrument status; 2.8.3 Procedures to make Task selections

[EN] English - K0460 Prepare the instrument 2-9
Issue 1
2.8.2 Procedure to see the instrument status
2.8.3 Procedures to make Task selections
When first using the calibrator, there are default measure
and source functions on the display:
• CH1 settings: RTD source, RTD type is PT100, scale is °C;
Automation is Nudge; see Chapter 3.
• CH2 settings: Current measure, see Chapter 3.
Procedure Overview Use the Tas k menu to complete these procedures:
• Set the calibrator functions on the display: item ; see
Section 2.8.4.
a. CH1: Channel 1 electrical function: Choose one option:
b. CH2: Channel 2 electrical function: Choose one option:
TAP
Configuration
2
1
3
Status
The amount of memory available (in MB and as a
% of the total on the device): SD Card (internal).
Charging or battery-powered, and the amount of
charge in 1% increments.
The date of the next calibration.
CH1:
source
CH2:
measure
TAP
2
1
C
B
A
None Resistance
Current RTD
Voltage CJ
Millivolts Observed*
TC (°C/°F)
TC (mV)
Frequency
None Voltage
Current Millivolts
Current (24V) Observed*
A