GE Druck DPI 620-IS - Set the Pressure Module to Zero; Example Procedure: Measure Pressure

[EN] English - K0460 Pressure indicator operation (MC 620-IS) 4-5
Issue 1
4.4.3 Set the pressure module to zero
Use this option to write a new zero pressure value to the
pressure module.
The sensor adjustment is permitted if it obeys this condition:
Note: To make a temporary adjustment for zero, use the Tare
function; see Section 2.9.1.
4.4.4 Example procedure: Measure pressure
Adjustment ≤ 10% FS positive pressure value
(for the Sensor)
1
3
4
Select Zero
TAP the window
(Maximise)
Select Settings
5
Accept the adjustment value
Go back to the Home window.
2
See the new reading
p1
p2
p1
p2
P2
P1
31 2